top of page

B&C Trimboards

Features

 

B&C Trim Boards begin with Radiata Pine from well managed and sustainable forests in Chile.  Sawn lumber is carefully kiln dried, conditioned and manufactured into finished products. 

Finishes

  1. Bare

  2. Latex Primed

  3. Oil primed

  4. LOSP treatment available for exterior uses.

All our B&C Trim Boards are finger jointed, edge glued, sanded, molded and primed adding additional stability, ensuring profiles that lay true and flat. In our process, we start with clear # 1 finger-joint block that is free from defects.  That enables us to offer 16’ and 20’ products that are fully reversible, surfaced in either S4S or S1S2E (Resawn textured) face.  

Profiles:

 

Products nominal and net sizes for B&C Trim Boards are available in 1″ x 2″ through 1″x 12″, 5/4″ x 4″ through 5/4″ x 12″ and 2″ x 2″ through 2″x 12″. Finished S4S, S1S2E and S4S4E, length in 8’, 12’, 16’ and 20’, no trim-backs, other length on request.

B&C Trim Boards

B&C Trim Boards “Treated Vascol Azure and Primed”

 

This product is pressure treated with LOSP to ensure long lasting durability and warranted protection against fungal decay, rot and insect damage.  These treated products are safe and effective for both interior and exterior (above ground) application, and are used in all types of construction projects, ranging from residential housing units to commercial office buildings, hotels and schools.

 

This provides flexibility for use on any project, in applications ranging from fascia boards, edge and corner trim boards, door and window casing and trim.  Protect your structure from weather and rain, while adding character and beauty to finished look.

 

Important Notice:

 

It is absolutely necessary that this product be maintained in a totally dry environment (including protection from moisture uptake from damp ground, snow or ice) until it is installed and before 30 days of installation it is painted with two or more high quality exterior 100% acrylic finishing coats.

 

Recommended Installation and Painting Instructions

 

  1. End-Seal with a 100% Acrylic paint all end and edge cuts to limit water migration.

  2. Use stainless steel, aluminum, or galvanized screw or nails to prevent discoloration.

  3. Putty and prime with a 100% Acrylic paint all nail holes.

  4. Do not install within 8”of ground level.

  5. Apply high performance, paintable caulking around windows, doors, and corners.

  6. Before 30 days after installation apply two or more coats of high quality exterior 100% acrylic finishing. See below for painting:

    • Ensure all surfaces are dry, clean and free of any contamination, e.g. dust, and mildew, etc. before painting.

    • Do not paint with temperatures’ below 55 F.

    • Finish 2 coats should provide a minimum of 4 dry mils.

    • Allow minimum 24 hours between coats.

    • Always follow the paint manufacturer’s application guidelines.

bottom of page